Is Roof Doctor NM Carlisle SynTec certified?

No — we've attended in-person Carlisle SynTec product-knowledge training (Albuquerque, NM), but Carlisle SynTec generally does not issue individual "certified" credentials for product training. We list this as training attended, never as certification. That distinction matters and we keep it strict.

What do you look for on a Carlisle SynTec install?

We check the finished roof against Carlisle SynTec's published install spec — nailing pattern, flashings, underlayment, accessories, and warranty registration paperwork. Sure-Weld TPO, Sure-Seal EPDM — mechanically attached vs fully adhered, HP-H seaming

Should I hire a Carlisle SynTec-authorized contractor?

For system warranty coverage (like GAF Golden Pledge or Owens Corning Platinum), yes — only manufacturer-authorized installers can register those warranties. For the roof itself, install quality matters more than the badge. We'll tell you honestly whether the bid you have satisfies the Carlisle SynTec warranty requirements.

Manufacturer notes

Carlisle SynTec

TPO / EPDM low-slope — inspector's-eye notes on install spec, warranty requirements, and what typically gets skipped on NM installs.

Training attended

Sure-Weld TPO, Sure-Seal EPDM — mechanically attached vs fully adhered, HP-H seaming

Albuquerque, NM

Owner-attested attendance. Carlisle SynTec does not typically issue individual certificates for product-knowledge sessions. Listed as training attended, never as certification.

What we check on a Carlisle SynTec install

Membrane thickness (mil) — 60-mil is the honest minimum for NM UV exposure.
Seam quality — heat-welded seams should be probed at completion, not just eyeballed.
Insulation R-value and taper — ponding water voids most single-ply warranties.
Termination bar and coping cap detail at parapets — where wind gets under the field.
Fully-adhered vs mechanically-attached — matters for wind ratings and puncture risk.

Questions to ask any contractor bidding Carlisle SynTec on your roof

Are you a Carlisle SynTec-authorized installer? Can you register the manufacturer's system warranty on my roof?
Which Carlisle SynTec product line are you installing? What's the exact spec — nailing pattern, underlayment, accessories?
Will you supply photos of critical details (valleys, penetrations, flashings) before dry-in and after tear-off?
Does the Carlisle SynTec warranty on this bid cover material only, labor + material, or full system with workmanship?
What's your written policy if a Carlisle SynTec warranty claim is denied later because install spec wasn't met?